In the last post, I talk about how to determine the required reinforcing for a rectangular beam. To elaborate more on the same topic, I am going to show you how to actually calculate out the capacity (using my handy dandy flowchart).
This most likely is just a refresher for many of you but it doesn't hurt to get more familiar with the calculation (especially if you haven't designed concrete for awhile).
To determine the moment capacity, , without having to memorize anything – you just need to follow the flowchart.
This flowchart also includes the stress/strain distribution diagram shown above.
Click Here to get the Flowchart
- (or ) Provided reinforcing steel (or steel ratio).
- Specified compressive strength. This is typically 3000, 4000, or 5000 psi.
- Specified yield strength of reinforcement. Usually 60,000 psi for new buildings and 40,000 psi for older buildings.
- Width of the beam.
- Usually the total beam depth – cover – 1/2 of the rebar diameter.
- Moment capacity of the section.
I've demonstrated the following “quick check” in an earlier post:
If we set and rearrange the equation, we get:
where the units for is [in²] and is [in].
|1||Calculate||This calculates the size of the compression stress block.|
|2||Calculate||This is the ratio between the T-C moment arm and d. It'll be used in step  to obtain the moment capacity.|
|3||Calculate||Location of the neutral axis from top fiber. See previous post/flowchart step  for the calculation of .|
|4||Calculate||This is the strain in the tension reinforcement.|
|5||Check||This checks whether the section is tension or compression controlled per er ACI 318, 22.214.171.124.|
|6||Calculate if answer in  is no (i.e., compression controls).||If compression controls, you have to reduce the factor based on this formula.|
|7||Calculate if answer in  is yes (i.e., tension controls).||This is the factor for tension controlled section.|
|8||Calculate||The moment capacity.|
|9||Calculate (Optional)||This is the reinforcement ratio that will cause “balanced strain condition” which is when these two events occur at the same time:|
In terms of design, you just want to make sure that your reinforcement ratio is less than this calculated value to prevent brittle failures.
Remember that this quick check is just an estimate. The point is just to make sure that we didn't mess up the actual calculation somewhere along the way.
We'll verify the real capacity in the table below.
Use the Flowchart
|3||7.2895 in||is calculated to be 0.85 for .|
|5||Yes, tension controls.|
|8||240 kip-ft||This is pretty close to the quick check (253 kip-ft) which means we probably didn't screw up arithmetically.|
|9||0.0214||Compares with , balanced reinforcement ratio is greater; therefore we will not get brittle failure which is good.|
There you have it. Is this helpful? Let me know in the comments below.